Turn around time can be greatly reduced due
to our in-house mold making capabilities.
Clay modeling is also available. Our Pattern
and Mold Making Division specializes in FRP
Tools, Epoxy Tools and Mass Cast.

MASS CAST
Mass cast tools are usually made of plastic
material; however, metal inserts are sometimes
built into the unit for added strength at certain
stress points. Either epoxy or polyurethane
may be used. Mass casting of plastics is usually
used where large tool surface is involved. The
dimensional stability of a mass cast tool is lower
than that of a laminated tool but is still well within
the normal tolerances of strength forming operations.

FRP (Fiberglass)
* Chip Brushes
* Quick-Change Laminating Rollers
* Radius and Corner Rollers
* Adjustable Volume Dispensers
* Diamond Cutting Tools & Blades
* Bristle Rollers
* Paddle Wheel Rollers

EPOXY TOOLS
Epoxy molds or aluminum epoxy molds are
reasonably fast in comparison to machined molds
and are a relatively inexpensive way to create
prototype and production tooling. New epoxy
products offer a much higher compression
strength and heat resistance. The molds can
withstand injection and compression pressure
with the use of aluminum standoffs or mold boxes.

Fiberglass
RTM
RIM